Altivar 212 Variable Speed Drives Page 14 Specifications

14 Altivar 212 variable speed drives I/O & Control Specifications I/O and Control Specifications Available internal supplies P24 Short-circuit and overload protection: 24 Vdc supply (min. 21 Vdc, max. 27 Vdc), maximum current: 200 mA Configurable Analog input VIB Voltage analog input, configurable as an analog input or as a PTC probe input. Voltage analog input: 0-10 Vdc, impedance 30 kW max. voltage 24 Vdc Max. sampling time: 22 ms 0.5 ms Resolution: 10 bits Accuracy: 0.6% for a temperature variation of 140 F (60 C) Linearity: 0.15% of the maximum value PTC probe input: 6 probes max. mounted in series Nominal value < 1.5 kW Trip resistance 3 kW, reset value 1.8 kW Short-circuit detection threshold < 50 W Configurable Analog output FM 1 switch-configurable (SW101) voltage or current analog output: Voltage analog output 0-10 Vdc, minimum load impedance 7.62 kW Current analog output X-Y mA by programming X and Y from 0 to 20 mA, maximum load impedance: 970 W Max. sampling time: 2 ms 0.5 ms Resolution: 10 bits Accuracy: 1 % for a temperature variation of 140 F (60 C) Linearity: 0.2% Configurable Relay outputs FLA, FLB, FLC 1 relay logic output, 1 N/O contact, and 1 N/C contact with common point Minimum switching capacity: 10 mA for 5 Vdc Maximum switching capacity: On resistive load (cos = 1): 5 A for 250 Vac or 30 Vdc On inductive load (cos = 0.4 and L/R = 7 ms): 2 A for 250 Vac or 30 Vdc Max. response time: 10 ms RYA, RYC 1 relay logic output, 1 N/O contact Minimum switching capacity: 3 mA for 24 Vdc Maximum switching capacity: On resistive load (cos = 1): 3 A for 250 Vac or 30 Vdc On inductive load (cos = 0.4 and L/R = 7 ms): 2 A for 250 Vac or 30 Vdc Max. response time: 7 ms 0.5 ms LI logic inputs F, R, RES 3 programmable logic inputs, 24 Vdc, compatible with level 1 PLC, IEC 65A-68 standard Impedance: 4.7 kW Maximum voltage: 30 Vdc Max. sampling time: 2 ms 0.5 ms Multiple assignment makes it possible to configure several functions on one input Positive logic (Source): State 0 if y 5 Vdc or logic input not wired, state 1 if u 11 Vdc Negative logic (Sink): State 0 if u 16 Vdc or logic input not wired, state 1 if y 10 Vdc Configurable Analog/Logic output VIA Switch-configurable voltage or current analog input: Voltage analog input: 0-10 Vdc, impedance 30 kW maximum voltage: 24 Vdc Analog current input: X-Y mA by programming X and Y from 0 to 20 mA, impedance = 250 W Max. sampling time: 3.5 ms 0.5 ms Resolution: 10 bits Accuracy: 0.6% for a temperature variation of 140 F (60 C) Linearity: 0.15% of the maximum value *This analog input is also configurable as a logic input. Consult the Altivar 212 Programming Manual for more information.

Previous PageNext Page